Schon Engineered Floors Installation Instructions

View the engineered floors hard surfaces installation care and maintenance guides.

Schon engineered floors installation instructions.

Once a board is nailed or glued to the floor it is deemed to be acceptable to the installer and homeowner. Place spacers 3 4 to 1 sticks between each layer or cross stack the layers for maximum exposure to ambient conditions. Install a wedge on the end of the board between the hardwood flooring and the wall allowing 13 mm expansion space. Sawyer ason structured wide plan flooring installation instructions as of une 22 8.

Lay the first row of flooring but do not glue into place. In open box open plastic wrap. Solid wood and bamboo should not be installed below grade. Installation requires a minimum of 16 mm plywood or 19 mm approved osb chipboard subfloor if installed over 16 400 mm centre to centre joist sub structure.

3 4 thick engineered planks should be nailed or stapled using a 3 4 solid wood flooring nailer or stapler of any brand using the recommended size staple or cleat for 3 4 solid wood installations. Locate the source of the moisture and correct if needed. Floating click installation instructions. Avoid installation of any boards shorter than 16 in the first four rows.

Use the floating floor installation method only. Use a pull bar to pull the last board into place from the opposite end. 11 p a g e w w w. Electric radiant heated floor.

Below grade engineered floors can be installed. If you still need help please reach out to us via the contact us page. Dry lay the next two rows of flooring in place sliding the tongue into the. Align the tongue side of the flooring boards against the backer board.

Elevate cartons from the floor by placing them on 2 x 2 lumber or equivalence. The installer is the final inspector of this product. The nailing schedule should be 1 to 3 from the ends and 8 to 10 in the field. Raise heat and increase ventilation until proper conditions are met.

Installing shaw engineered hardwood doesn t have to be a difficult task especially when following their floating installation instructions. Skip to main content area. H o m e r w o o d. Acclimation temperature range is 60 f 80 f and relative humidity rh of 35 55.