Replacing Loose Floor Tiles In A Hot Mop Shower

Set the tile aside.

Replacing loose floor tiles in a hot mop shower.

If they are stuck on good and just dirty clean them up. Use a grout removal rake to remove the grout from around the tile being careful not to cut through into the wall or damage adjoining tiles. Install an appropriate two piece shower drain the bottom half is fastened to the subfloor and the top half is fastened over the hot asphalt and felt paper combination. He used silicone to hold the tiles in.

You may have to repair rubber or vinyl membranes to assure there isn t a leak underneath the tiles you are replacing and the methods for doing so vary depending on the membrane used. Lift out the loose tile with a putty knife. The tiles must be chipped away in small pieces with a hammer and a chisel. 3 get some ceramic tile adhesive or thinset tile cement and apply it to the substrate with a notched trowel.

In some cases the old shower tiles will simply come out of the tile installation with no problems. Lift out the loose tile with a putty knife. If you hire someone get references. Add wood blocking up to 10 12 inches around the base of the shower area in between the wall studs to secure felt paper.

Remove the tile adhesive by applying paint remover and scrubbing with a scrub brush. If the wall tiles are loose remove the first course of wall tile. Make sure that the base floor surface is even and free of any stubborn tile adhesives as a smooth surface is. How to repair a loose shower tile found a guy on craig s list to update my shower big mistake.

The hardest part about replacing a shower tile is removing the old tile. Use a self leveling concrete compound on the floor making sure it slopes down towards the drain. Hammer the end of the chisel with a 3 pound sledgehammer until the tile dislodges. Heating the tile with a warm iron will loosen any adhesive that might still be holding the tile.

Step 4 use a hammer and chisel to chip away the broken tile starting from the hole in the centre. This old house plumbing and heating expert richard trethewey and tile expert joe ferrante team up to repair a leaky shower valve installation. Let everything dry out. This is how i fixed my shower time that had come loose.

Chisel all the way down. In many other cases the broken and cracked shower tiles can be more difficult to remove. Carefully lift the loose tile with a putty knife working from center to edges on all four sides.