Repair Radiator Hole In Floor

In particular there was one thing the floor guy did that was completely asinine to quote the roof guy.

Repair radiator hole in floor.

You will need to isolate it by shutting off the radiator valves. In total there were six holes each about 1 5. If you find a meduim to large hole your radiator is beyond temporary repair. The soft particles of the sealant will not clog the radiator which can be a common issue with typical sealants.

Remove any paint from the area using an abrasive paper or wire brush i use a rotary wire brush in the end of a drill. When you have located the leak then isolate the radiator by closing the valves at either end and collect the dripping water in a bowl until no more appears and the area around the hole s is dry. In emergencies you can rely on miracle seal to fix a leaky radiator with no fuss. Method 3 recommended the plug cutter.

This will need to be captured in a bucket if you cannot plug the hole. Sand flush use a sharp chisel and micro sanding on the patch if you don t want to scratch the surrounding flooring. A plug cutter is very similar to a hole saw with the exception that the dimension listed will be the diameter of the plug instead of the hole. Miracle seal can repair small cracks without clogging the system.

Mix stain to blend the patch to the existing floor. Use glue and and hammer to tap the patch into the hole. Use the hole saw to drill into your scrap board then remove the wood plug from the hole saw and sand it down a bit if needed.